Starter Vape Kit packing list without surprises guide
We work with B2B buyers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Published 30 March 2026 · VapeWholesaleHub · Reading time 5 min
How the price is actually built
If you are comparing three quotes for starter vape kit, compare the paperwork first. Test reports, artwork files, batch coding and the replacement clause tell you more about a supplier than the unit price on page one.
Custom printing raises the unit price and lowers the marketing cost. For B2B buyers the break-even is usually reached on the second or third repeat order, not the first, so we quote both branded and neutral options.
A landed cost sheet for starter vape kit has five lines: unit price, packaging, freight, duty and the cost of defects. Quoting only the first line is how buyers end up surprised at the fourth.
Compliance without the last-minute scramble
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Artwork approval is a two stage process: a digital proof for text and layout, then a physical dummy for colour and finish. Skipping the dummy is the single most common cause of a reprint.
Batch consistency and why it matters
8 separate checks run before a carton is sealed: electrical, mechanical, leak, finish and packaging. Anything outside tolerance is quarantined the same day and reported to you, rather than shipped with a hope and a discount.
Battery safety is not a marketing line. Cells are matched by capacity and internal resistance before assembly, charging boards are checked for cut-off voltage, and any unit that fails the cut-off test never reaches packing.
- Document pack prepared per destination market
- Consolidated or split shipping, quoted both ways
- Reference sample retained from every batch
- Private label files archived for future rebrands
- Standing reorder schedule with a fixed cut-off
- Specification locked in writing before production starts
Getting the carton there intact
For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.
Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.
Specification summary
| Battery | 500 mAh |
| Pod capacity | 3.0 ml |
| Coil resistance | 0.8 ohm |
| Included | Device, pod, cable |
| Charging | USB-C 5V/1A |
| Packaging | Retail box |
| Minimum order | 200 units per SKU, mixed cartons allowed |
| Lead time | 30 working days after artwork approval |
If any of this is unclear, the fastest route is a message rather than a meeting. Send the market you sell into and the price band you work in, and you will get a specific answer instead of a brochure.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How long does production take?
Around 30 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 60 units. We would rather you handle the sample than approve a specification from a photograph.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz