How to source Starter Vape Kit contract pre-order guide
We ship starter vape kits to distributors, chain buyers and independent shops. What follows is the material we normally cover in a first conversation: what we hold in stock, how we test it, how it ships, and what happens when a carton arrives damaged.
Published 04 August 2025 · VapeWholesaleHub · Reading time 9 min
Getting the documents right
Buyers come to us for starter vape kit after a bad quarter: dead stock on one side, empty shelves on the other. The cause is usually the same, an assortment built from a catalogue instead of from sell-through data. This page explains how we rebuild that balance for B2B buyers.
Advertising rules are stricter than product rules in most markets. Claims about cessation, health or comparative performance should stay off packaging and off your product pages unless your legal team has signed them off.
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Getting the carton there intact
Damage in transit is nearly always a packing decision, not bad luck. Double-walled cartons, internal dividers and a drop-tested configuration cost a little more and save the argument at the other end.
For repeat buyers we hold a shipping schedule rather than shipping on request. A fixed weekly cut-off means your reorder lands before the shelf empties instead of after.
Turning shelf space into repeat visits
Seasonality in starter vape kits is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.
- Named account contact who has handled the product
- Document pack prepared per destination market
- Batch codes traceable from carton back to production date
- Specification locked in writing before production starts
- Seven-day defect reporting with replace-or-credit
- Reference sample retained from every batch
Assortment planning without the guesswork
A practical starting order for B2B buyers is 100 units across two or three SKUs, not 100 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.
The first question we ask is not what you want to spend. It is what your customer already buys. Answer that and the starter vape kit list writes itself; skip it and you end up with a pallet of stock that photographs well and sells badly.
Specification summary
| Battery | 500 mAh |
| Pod capacity | 2.0 ml |
| Coil resistance | 1.2 ohm |
| Included | Device, pod, cable |
| Charging | USB-C 5V/1A |
| Packaging | Retail box |
| Minimum order | 100 units per SKU, mixed cartons allowed |
| Lead time | 25 working days after artwork approval |
The detail above is what we hold ourselves to on every shipment, including the small ones. It is also the list we will walk through with you before the first order.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
How long does production take?
Around 12 working days after artwork approval for stock configurations, plus transit. Custom runs add roughly a week for tooling and a physical dummy. We confirm the date in writing on the order acknowledgement.
Can we order samples before committing?
Yes. Sample orders are shipped by air express and the cost is credited against your first production order above 100 units. We would rather you handle the sample than approve a specification from a photograph.
Related reading
Need a quotation on starter vape kits?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz